Old Turntables Repair & Restoration

· New Life for Vintage Audio ·

Viscous damped unipivot tonearm 12″

The arm is made of magnesium alloy.
All mounting dimensions are equivalent to the Gray 108.
The needle and the screw are made from 1045 steel.
The tonearm is fully equipped with everything being needed to install on the turntable as you can see it on the photos.
The tonearm is equipped with a cable (2 feet) and clips Cardas.
Also, there is an instruction for installing and correct setting.

Spindle to pivot 270mm.

420 USD

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Viscous damped unipivot tonearm 12″

Clamp
Clamp
Starlight 80
Viscous damped unipivot tonearm 12″. Luxury version.
Phono preamplifier.
Tonearm universal lifter gold.
Idler wheel for GATES CB-77
Tonearm lifting device for installation on a plinth.
Tonearm lifting device for Micro-Trak 303/306
DIY amplifier 10W ALEPH-M. Based on the Nelson Pass design.
Viscous damped tonearm
Viscous damped unipivot tonearm 9″
Binding post
Viscous damped unipivot tonearm 12″
Slide shell for Gray Research tonearms 108, 208 mono.
Slide shell for Gray Research tonearms 103.
Slide shell for Gray Research tonearms 108, 208.
Headshell magnesium alloy.
Arm rest for Para Flux tonearm.
Vibration-damping support.
GRAY 108 tonearm clone from magnesium alloy.
GRAY 206 tonearm clone magnesium alloy.
Broadcast turntable Gates CB-11
Arm rest for Gray Research 108/208
Russco broadcast turntable idler shaft.